D-Link DWS-4026 Product Manual - Page 338

D-Link Unified Access System Software User Manual 12/10/09 IP DSCP MAPPING CONFIGURATION Use the IP DSCP Mapping Configuration page to map an IP DSCP value to an internal traffic class. To display the IP DSCP Mapping Configuration page, click LAN >QoS > Class of Service > IP DSCP Mapping Configuration in the navigation menu. Figure 238: IP DSCP Mapping Configuration Field Slot/Port IP DSCP Values Traffic Class Table 214: IP DSCP Mapping Configuration Fields Description The menu contains all CoS configurable interfaces. The only option is Global, which means that the IP DSCP mapping configuration applies to all interfaces and cannot be applied on a per-interface basis. Lists the IP DSCP values to which you can map an internal traffic class. The values range from 0-63. The traffic class is the hardware queue for a port. Higher traffic class values indicate a higher queue position. Before traffic in a lower queue is sent, it must wait for traffic in higher queues to be sent. Valid range is 0 to 7. • If you make changes to the page, click Submit to apply the changes to the system. Click Restore Defaults to reset all interfaces to the default trust value. COS INTERFACE CONFIGURATION Use the CoS Interface Configuration page to apply an interface shaping rate to all ports or to a specific port. To display the CoS Interface Configuration page, click LAN > QoS > Class of Service > CoS Interface Configuration in the navigation menu. Page 338 Configuring Class of Service Document 34CSFP6XXUWS-SWUM100-D7