D-Link DWS-4026 Product Manual - Page 285
IP Interface Configuration, LAN > L3 Features > IP > Interface Configuration
UPC - 790069325533
View all D-Link DWS-4026 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
Software User Manual 12/10/09 D-Link Unified Access System IP INTERFACE CONFIGURATION Use the IP Interface Configuration page to update IP interface data for this switch. To display the page, click LAN > L3 Features > IP > Interface Configuration in the navigation tree. Field Slot/Port IP Address Subnet Mask Routing Mode Administrative Mode Link Speed Data Rate Forward Net Directed Broadcasts Active State Figure 195: IP Interface Configuration Table 177: IP Interface Configuration Fields Description Select the interface to configure from the dropdown menu. The dropdown menu contains logical interfaces, including loopback interfaces and VLAN routing interfaces. Enter the IP address for the interface. Enter the subnet mask for the interface. This is also referred to as the subnet/network mask, and defines the portion of the interface's IP address that is used to identify the attached network. Setting this Enables or Disables routing for an interface. By default, routing is disabled on port-based routing interfaces and enabled on VLAN-based routing interfaces. The Administrative Mode of the interface. The default value is Enable. An integer representing the physical link data rate of the specified interface. This data is valid only for physical interfaces and is measured in Megabits per second (Mbps). Select how network directed broadcast packets should be handled. If you select Enable from the dropdown menu network directed broadcasts are forwarded. If you select Disable they are dropped. The default value is Disable. The state of the specified interface is either Active or Inactive. An interface is considered active if the link is up and it is in forwarding state. Document 34CSFP6XXUWS-SWUM100-D7 Configuring Global and Interface IP Settings Page 285