D-Link DWS-4026 Product Manual - Page 360

D-Link Unified Access System Software User Manual 12/10/09 Figure 250: Captive Portal Global Configuration The following table describes the global CP fields you can view or configure. Table 223: Captive Portal Global Configuration Field Description Enable Captive Portal Select the check box to enable the CP feature on the switch. Clear the check box to disable the captive portal feature. CP Global Shows whether the CP feature is enabled. Operational Status CP Global Disable Reason If CP is disabled, this field displays the reason, which can be one of the following: • None • Administratively Disabled • No IPv4 Address • Routing Enabled, but no IPv4 routing interface Additional HTTP Port HTTP traffic uses port 80, but you can configure an additional port for HTTP traffic. Enter a port number between 0-65535 (excluding ports 80, 443, and the configured switch management secure port). Additional HTTP Secure Port HTTP traffic over SSL (HTTPS) uses port 443, but you can configure an additional port for HTTPS traffic. Enter a port number between 0-65535 (excluding ports 80, 443, and the configured switch management secure port). Peer Switch When clustering is supported on the switch, enter a value to determine how often the switch sends Statistics Reporting its authenticated client statistics to the Cluster Controller. The interval is in seconds. Enter a value Interval of 0 to prevent the switch from reporting the statistics. Authentication Timeout To access the network through a portal, the wireless client must first enter authentication information on an authentication Web page. Enter the number of seconds to keep the authentication session open with the client. When the timeout expires, the switch disconnects any active TCP or SSL connection with the client. Page 360 Captive Portal Configuration Document 34CSFP6XXUWS-SWUM100-D7