D-Link DWS-4026 Product Manual - Page 550

D-Link Unified Access System Software User Manual 12/10/09 CONFIGURING A VIRTUAL ACCESS POINT The following example shows how to configure the default virtual access point (VAP) profile on the switch. After the switch authenticates an AP it discovers on the network, it assigns the default profile to the AP. In order for the switch and AP to discover each other, the WLAN Switch feature must be enabled on the UWS, and the Managed Mode must be enabled on the AP. The default profile in this example has three enabled VAPs with the following settings: Network (SSID) Visitor Corporate Voice VLAN 10 20 30 Table 343: VAP Configuration Example Settings Security None Redirect http://www.dlink.com.tw WPA Personal WPA Enterprise None None Client QoS http://www.dlink.com.tw Bandwidth Restrictions None DiffServ Policy Up The Voice network uses the default RADIUS server configured on the system to authenticate clients and has the L2 Distributed Tunneling Mode enabled. When L2 Distributed tunneling is enabled, note the following network considerations: • If APs are located in different subnets, the client VLANs must also be separated by a router so that the VLANs do not form a single bridge segment. • If the IP addresses of the APs are on the same subnet, all VLANs used by the wireless clients must also be located in the same bridge segment. The Voice network also uses a DiffServ policy to expedite the voice traffic. The policy must already be configured in order to associate it with the Voice network. You configure the policy by using the pages available from the LAN > QoS > Differentiated Services folder. For information about configuring DiffServ policies, see "Configuring Differentiated Services for VoIP" on page 554. 1 Access the WLAN > Administration > Basic Setup page, and then click the SSID tab. By default, Network 1 is enabled and uses "Guest Network" as the SSID. 2 Configure the first VAP. a. Click Edit for Network 1 to access the Wireless Network Configuration page for that network. b. Delete the existing SSID and enter Visitor in the SSID field. c. In the VLAN field, enter 10. d. In the Redirect field, select the HTTP option. e. In the Redirect URL field, enter www.dlink.com.tw f. In the Bandwidth Limit Down field, enter 3000000 to limit the download speed to 3 Mbps for the VAP. g. In the Bandwidth Limit Up field, enter 100000 to limit the upload speed to 1 Mbps for the VAP. h. Click Submit to apply the settings to the switch. Page 550 Configuring a Virtual Access Point Document 34CSFP6XXUWS-SWUM100-D7