Dell PowerConnect 3548 Command Line Interface Guide - Page 102
bridge multicast filtering, bridge multicast address
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Example The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245 on port 1/e16 to the bridge table. Console(config)# interface vlan 2 Console(config-if)# bridge address 3aa2.64b3.a245 ethernet 1/e16 permanent bridge multicast filtering The bridge multicast filtering Global Configuration mode command enables filtering Multicast addresses. Use the no form of this command to disable filtering Multicast addresses. Syntax • bridge multicast filtering • no bridge multicast filtering Default Configuration Filtering Multicast addresses is disabled. All Multicast addresses are flooded to all ports. Command Mode Global Configuration mode. User Guidelines • If Multicast routers exist on the VLAN, do not change the unregistered Multicast addresses state to drop on the switch ports. • If Multicast routers exist on the VLAN and IGMP-snooping is not enabled, use the bridge multicast forward-all command to enable forwarding all Multicast packets to the Multicast switches. Example The following example enables bridge Multicast filtering. Console(config)# bridge multicast filtering bridge multicast address The bridge multicast address Interface Configuration (VLAN) mode command registers a MAC-layer Multicast address in the bridge table and statically adds ports to the group. Use the no form of this command to unregister the MAC address. 102 Address Table Commands