Dell PowerConnect 3548 Command Line Interface Guide - Page 179
port storm-control include-multicast, Multicast packets are not counted.
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
The following table describes the fields shown in the display. Field Description InOctets Counted received octets. InUcastPkts Counted received Unicast packets. InMcastPkts Counted received Multicast packets. InBcastPkts Counted received Broadcast packets. OutOctets Counted transmitted octets. OutUcastPkts Counted transmitted Unicast packets. OutMcastPkts Counted transmitted Multicast packets. OutBcastPkts Counted transmitted Broadcast packets. FCS Errors Counted received frames that are an integral number of octets in length but do not pass the FCS check. Single Collision Frames Counted frames that are involved in a single collision, and are subsequently transmitted successfully. Late Collisions Number of times that a collision is detected later than one slotTime into the transmission of a packet. Oversize Packets Counted frames received that exceed the maximum permitted frame size. Internal MAC Rx Errors Counted frames for which reception fails due to an internal MAC sublayer receive error. Received Pause Frames Counted MAC Control frames received with an opcode indicating the PAUSE operation. Transmitted Pause Frames Counted MAC Control frames transmitted on this interface with an opcode indicating the PAUSE operation. port storm-control include-multicast The port storm-control include-multicast Interface Configuration (Ethernet) mode command counts Multicast packets in Broadcast storm control. Use the no form of this command to disable counting Multicast packets. Syntax • port storm-control include-multicast • no port storm-control include-multicast Count unknown Unicast packets. Default Configuration Multicast packets are not counted. Ethernet Configuration Commands 179