Dell PowerConnect 3548 Command Line Interface Guide - Page 480
map protocol protocols-group
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 480 highlights
Command Mode Interface Configuration (Ethernet, port-channel) mode. User Guidelines Use this command to override the FDB decision, and forward the packet to the uplink. Please note that the packet is still subject to all filtering decisions. The following example overrides the FDB decision, and sends all the Unicast, Multicast and Broadcast traffic to specified ethernet port. Console(config)# interface ethernet 1/e5 Console(config-if)# switchport protected ethernet 2/g1 map protocol protocols-group The map protocol protocols-group VLAN Configuration mode command maps a protocol to a protocol group. Protocol groups are used for protocol-based VLAN assignment. Use the no form of this command to delete a protocol from a group. Syntax • map protocol protocol [encapsulation] protocols-group group • no map protocol protocol encapsulation • protocol - The protocol is a 16 or 40 bits protocol number or one of the following names, ip, ipx or arp. The protocol number is in Hex format (Range: 0600 - FFFF). • encapsulation - One of the following values: ethernet or protocols-group. If no option is indicated the default is ethernet. • group - Protocol group number. (Range: 1 - 2147483647) Default Configuration This command has no default configuration. Command Mode VLAN Configuration mode. User Guidelines There are no user guidelines for this command. 480 VLAN Commands