Dell PowerConnect 3548 Command Line Interface Guide - Page 214
ipv6 address autoconfig, ipv6 icmp error-interval, Interface Configuration Ethernet, VLAN
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
ipv6 address autoconfig The ipv6 address autoconfig Interface Configuration mode command enables automatic configuration of IPv6 addresses using stateless autoconfiguration on an interface. Addresses are configured depending on the prefixes received in Router Advertisement messages. , Use the no form of this command to disable address autoconfiguration on the interface. Syntax • ipv6 address autoconfig • no ipv6 address autoconfig Default Configuration Address autoconfiguration is enabled on the interface, no addresses are assigned by default. Command Mode Interface Configuration (Ethernet, VLAN, Port-channel) mode. User Guidelines • When address autoconfig is enabled, router solicitation ND procedure is initiated to discover a router and assign IP addresses to the interface, based on the advertised on-link prefixes. • When disabling address autoconfig, automatically generated addresses assigned to the interface are removed. • The default state of the address autoconfig is 'enabled'. To enable an IPv6 interface without address autoconfig, use the enable ipv6 no-autoconfig command. Example The following example enables automatic configuration of IPv6 addresses using stateless autoconfiguration on VLAN 1. Console (config)# interface vlan 1 Console (config-if)# ipv6 address autoconfig ipv6 icmp error-interval The ipv6 icmp error-interval Global Configuration mode command configures the rate limit interval and bucket size parameters for IPv6 Internet Control Message Protocol (ICMP) error messages. Use the no form of this command to return the interval to its default setting. 214 IPv6 Addressing