Dell PowerConnect 3548 Command Line Interface Guide - Page 104
bridge multicast forbidden address, Consoleconfig, 5e.02.0203
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
bridge multicast forbidden address The bridge multicast forbidden address Interface Configuration (VLAN) mode command forbids adding a specific Multicast address to specific ports. Use the no form of this command to return to the default configuration. Syntax • bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} {add | remove} {ethernet interface-list | port-channel port-channel-number-list} • no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} • add - Adds ports to the group. • remove - Removes ports from the group. • mac-multicast-address - A valid MAC Multicast address. • ip- multicast-address - A valid IP Multicast address. • interface-list - Separate non-consecutive Ethernet ports with a comma and no spaces; hyphen is used to designate a range of ports. • port-channel-number-list - Separate non-consecutive valid port-channels with a comma and no spaces; a hyphen is used to designate a range of port-channels. Default Configuration No forbidden addresses are defined. Command Modes Interface Configuration (VLAN) mode. User Guidelines • Before defining forbidden ports, the Multicast group should be registered. Examples The following example forbids MAC address 0100.5e02.0203 on port 2/e9 within VLAN 8. Console(config)# interface vlan 8 Console(config-if)# bridge multicast address 0100.5e.02.0203 Console(config-if)# bridge multicast forbidden address 0100.5e02.0203 add ethernet 2/e9 104 Address Table Commands