Dell PowerConnect 3548 Command Line Interface Guide - Page 346
snmp-server v3-host, Consoleconfig, 1.1.1 management 2
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 346 highlights
• If a trap and inform are defined on the same target, and an inform was sent, the trap is not sent. • The IPv6Z address format: % - interface-name - vlan | ch | isatap | | 0 - integer - | - decimal-number - 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 - physical-port-name - Designated port number, for example 1/e16. If the egress interface is not specified, the default interface is selected. Specifying interface zone=0 is the same as not defining an egress interface. Example The following example enables SNMP traps for host 10.1.1.1 with community string "management" using SNMPv2. Console(config)# snmp-server host 10.1.1.1 management 2 snmp-server v3-host The snmp-server v3-host Global Configuration mode command specifies the recipient of Simple Network Management Protocol Version 3 notifications. Use the no form of this command to remove the specified host. Syntax • snmp-server v3-host {ip4-address | ip6-address | hostname} | hostname} username [traps | informs] {noauth | auth | priv} [udp-port port] [filter filtername] [timeout seconds] [retries retries] • no snmp-server v3-host {ip4-address | ip6-address | hostname} username [traps | informs] • ip4-address - The host IPv4 address (the targeted recipient). • ip6-address - The host IPv6 address (the targeted recipient). When the IPv6 address is a Link Local address (IPv6Z address), the outgoing interface name must be specified. Refer to the usage guidelines for the interface name syntax. • hostname - Specifies the name of the host. (Range: 1 - 158 characters) • username - Specifies the name of the user to use to generate the notification. (Range: 1 - 25) • traps - Indicates that SNMP traps are sent to this host. • informs - Indicates that SNMP informs are sent to this host. • noauth - Indicates no authentication of a packet. • auth - Indicates authentication of a packet without encrypting it. • priv - Indicates authentication of a packet with encryption. 346 SNMP Commands