Dell PowerConnect 3548 Command Line Interface Guide - Page 536
dot1x radius-attributes vlan, form of this command to disable user-based VLAN assignment.
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 536 highlights
Example The following command enables sending traps when a MAC address was failed in authentication of the 802.1X MAC authentication access control. console config-if(Config)# dot1x traps mac-authentication failure dot1x radius-attributes vlan The dot1x radius-attributes vlan Interface Configuration mode command enables user-based VLAN assignment. Use the no form of this command to disable user-based VLAN assignment. Syntax • dot1x radius-attributes vlan • no dot1x radius-attributes vlan Default Configuration Disabled. Command Mode Interface configuration (Ethernet) mode User Guidelines • The dot1x radius-attributes vlan command configuration is allowed only when the port is Forced Authorized. • RADIUS attributes are supported only in the multiple sessions mode (multiple hosts with authentication). • When RADIUS attributes are enabled and the RADIUS Accept message does not contain as an attribute the supplicant's VLAN, then the supplicant is rejected. • Packets to the supplicant are sent untagged. • After successful authentication the port remains member in the unauthenticated VLANs and in the Guest VLAN. Other static VLAN configuration is not applied on the port. • If the supplicant VLAN does not exist on the switch, the supplicant is rejected. Examples The following command enables user-based VLAN assignment. console config-if(Config)# dot1x radius-attributes vlan 536 802.1x Commands