Dell PowerConnect 3548 Command Line Interface Guide - Page 369
spanning-tree mst cost, spanning-tree mst configuration
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 369 highlights
spanning-tree mst cost The spanning-tree mst cost Interface Configuration mode command configures the path cost for multiple Spanning Tree (MST) calculations. If a loop occurs, the Spanning Tree considers path cost when selecting an interface to put in the forwarding state. Use the no form of this command to return to the default configuration. Syntax • spanning-tree mst instance-id cost cost • no spanning-tree mst instance-id cost • instance-ID - ID of the spanning -tree instance. (Range: 1 - 15) • cost - The port path cost. (Range: 1 - 200,000,000) Default Configuration Default path cost is determined by port speed and path cost method (long or short) as shown below: Interface Port-channel Gigabit Ethernet (1000 Mbps) Fast Ethernet (100 Mbps) Ethernet (10 Mbps) Long 20,000 20,000 200,000 2,000,000 Short 4 4 19 100 Command Mode Interface Configuration (Ethernet, port-channel) mode. User Guidelines There are no user guidelines for this command. Example The following example configures the MSTP instance 1 path cost for Ethernet port 1/e9 to 4. Console(config) # interface ethernet 1/e9 Console(config-if) # spanning-tree mst 1 cost 4 spanning-tree mst configuration The spanning-tree mst configuration Global Configuration mode command enables configuring an MST region by entering the Multiple Spanning Tree (MST) mode. Spanning-Tree Commands 369