Dell PowerConnect 3548 Command Line Interface Guide - Page 335
SNMP Commands, snmp-server community, community [ipv4-address | ipv6-address]
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 335 highlights
SNMP Commands snmp-server community The snmp-server community Global Configuration mode command configures the community access string to permit access to the SNMP protocol. Use the no form of this command to remove the specified community string. Syntax • snmp-server community community [ro | rw | su] [ipv4-address | ipv6-address] [view view-name] • snmp-server community-group community group-name [ipv4-address | ipv6-address] • no snmp-server community community [ipv4-address | ipv6-address] • community - Community string that acts like a password and permits access to the SNMP protocol. (Range: 1 - 20 characters) • ro - Indicates read-only access (default). • rw - Indicates read-write access. • su - Indicates SNMP administrator access. • view view-name - Name of a previously defined view. The view defines the objects available to the community. It's not relevant for su, which has an access to the whole MIB. If unspecified, all the objects except of the community-table and SNMPv3 user and access tables are available. (Range: 1 - 30 characters) • ipv4-address - Management station IPv4 address. Default is all IP addresses. • ipv6-address - Management station IPv6 address. Default is all IP addresses. • group-name - Specifies the name of a previously defined group. A group defines the objects available to the community. (Range: 1 - 30 characters) Default Configuration No communities are defined. Command Mode Global Configuration mode. SNMP Commands 335