Dell PowerConnect 3548 Command Line Interface Guide - Page 103
A valid MAC Multicast address.
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Syntax • bridge multicast address {mac-multicast-address | ip-multicast-address} • bridge multicast address {mac-multicast-address | ip-multicast-address} [add | remove] {ethernet interface-list | port-channel port-channel-number-list} • no bridge multicast address {mac-multicast-address | ip-multicast-address} • add - Adds ports to the group. If no option is specified, this is the default option. • remove - Removes ports from the group. • mac-multicast-address - A valid MAC Multicast address. • ip- multicast-address - A valid IP Multicast address. • interface-list - Separate non-consecutive Ethernet ports with a comma and no spaces; a hyphen is used to designate a range of ports. • port-channel-number-list - Separate non-consecutive port-channels with a comma and no spaces; a hyphen is used to designate a range of ports. Default Configuration No Multicast addresses are defined. Command Mode Interface configuration (VLAN) mode. User Guidelines • If the command is executed without add or remove, the command only registers the group in the bridge database. • Static Multicast addresses can only be defined on static VLANs. Examples The following example registers the MAC address: Console(config)# interface vlan 8 Console(config-if)# bridge multicast address 01:00:5e:02:02:03 The following example registers the MAC address and adds ports statically. Console(config)# interface vlan 8 Console(config-if)# bridge multicast address 01:00:5e:02:02:03 add ethernet 1/e1-e9, 2/e2 Address Table Commands 103