Dell PowerConnect 3548 Command Line Interface Guide - Page 219
ipv6 default-gateway
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
ipv6 default-gateway The ipv6 default-gateway Global Configuration mode command defines an IPv6 default gateway. Use the no form of this command to remove the default gateway. Syntax • ipv6 default-gateway ipv6-address • no ipv6 default-gateway • ipv6-address - IPv6 address of the next hop that can be used to reach that network. When the IPv6 address is a Link Local address (IPv6Z address), the outgoing interface name must be specified. Refer to the usage guidelines for the interface name syntax. Default Configuration No default gateway is defined. Command Mode Global Configuration mode. User Guidelines • The IPv6Z address format: % - interface-name - vlan | ch | isatap | | 0 - integer - | - decimal-number - 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 - physical-port-name - Designated port number, for example 1/e16. • Configuring a new default GW without deleting the previous configured information overwrites the previous configuration. • A configured default GW has a higher precedence over automatically advertised (via router advertisement message). • If the egress interface is not specified, the default interface will be selected. Specifying interface zone=0 is equal to not defining an egress interface. Example The following example defines an IPv6 default gateway. Console(config)# ipv6 default-gateway fe80::11 IPv6 Addressing 219