Dell PowerConnect 3548 Command Line Interface Guide - Page 105
bridge multicast unregistered, bridge multicast forward-all, Interface configuration Ethernet - restore configuration
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
bridge multicast unregistered The bridge multicast unregistered Interface Configuration mode command configures the forwarding state of unregistered multicast addresses. Use the no form of this command to return to default. Syntax • bridge multicast unregistered {forwarding | filtering} • no bridge multicast unregistered • forwarding - Forward unregistered multicast packets. • filtering - Filter unregistered multicast packets. See usage guidelines for the case where the port is a router port. Default Configuration Forwarding Command Modes Interface configuration (Ethernet, Port-Channel) mode Default Configuration • Unregistered multicast filtering should not be enabled on ports that are connected to routers, because the 224.0.0.x address range should not be filtered. Routers would not necessarily send IGMP reports for the 224.0.0.x range. Examples This example configures the forwarding state of unregistered multicast addresses to allow forwarding. Console (config)# bridge multicast unregistered forwarding bridge multicast forward-all The bridge multicast forward-all Interface Configuration (VLAN) mode command enables forwarding all Multicast packets on a port. Use the no form of this command to restore the default configuration. Address Table Commands 105