Dell PowerVault MD3200 Owner's Manual - Page 230
Remove the storage array with the Unresponsive status from the EMW
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 230 highlights
To recover from an unresponsive storage array: 1 Check the Tree View in the EMW to see if all storage arrays are unresponsive. 2 If any storage arrays are unresponsive, check the storage management station network connection to make sure that it can reach the network. 3 Ensure that the RAID controller modules are installed and that there is power to the storage array. 4 If there a problem with the storage array, correct the problem. 5 Perform one of these actions, depending on how your storage array is managed: • Out-of-band managed storage array-Go to step 6. • In-band managed storage array - Go to step 12. 6 For an out-of-band managed storage array, ensure that the RAID controller modules are network accessible by using the ping command to make sure that the RAID controller module can be reached. Type one of these commands, and press Enter. • ping • ping 7 If the verification is successful, see step 8, if not, see step 9. 8 Remove the storage array with the Unresponsive status from the EMW, and select Add Storage Array to add the storage array again. 9 If the storage array does not return to Optimal status, check the Ethernet cables to make sure that there is no visible damage and that they are securely connected. 10 Make sure the appropriate network configuration tasks have been performed. For example, make sure that IP addresses have been assigned to each RAID controller module. 11 If there is a cable or network accessibility problem, see step 20, if not step 12. 230 Troubleshooting: Your Storage Array Software