HP 450c Service Manual - Page 132
Removing the Left EndĆCover, Remove the Left Rollfeed Assembly
View all HP 450c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Removing the Left EndĆCover Removal 1. Remove the top cover ' page 8Ć8. 2. Remove the Left Rollfeed Assembly ' page 8Ć9. 3. Release the three clips at the bottom of the endĆcover: first the side clip, then the front and back clips. These may be stiff. A C B 4. Pull the endĆcover up, and remove it from the Printer. Reassembling: It's not easy to reinstall the endĆcovers on the Printer. With some practice, you should learn the knack. As a guide, before you replace an endĆcover, take a look at the various clips on its inside, and identify where they fit on the Printer. Make sure that the primer plunger is installed properly when reinstalling the endĆcover. 8-10 HP DesignJet 430, 450C and 455CA Printers Removal and Installation
8-10
Removal and Installation
HP DesignJet 430, 450C and 455CA Printers
Removing the Left EndĆCover
Removal
1.
Remove the top cover
'
page 8Ć8.
2.
Remove the Left Rollfeed Assembly
'
page 8Ć9.
3.
Release the three clips at the bottom of the endĆcover: first the side clip,
then the front and back clips.
These may be stiff.
A
B
C
4.
Pull the endĆcover up, and remove it from the Printer.
Reassembling:
It's not easy to reinstall the endĆcovers on the Printer.
With some practice, you should learn the knack. As a guide, before you
replace an endĆcover, take a look at the various clips on its inside, and
identify where they fit on the Printer.
Make sure that the primer plunger is installed properly when
reinstalling the endĆcover.