HP 450c Service Manual - Page 28
Load Media + Cartridges + Data, Steady DLM, Model ID no.
View all HP 450c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
D K E L F M A G N B H O C I J Steady FKL Load Media + Cartridges + Data: Problems when initializing the carriage. Possible causes: D Carriage assembly is not present. D Faulty or badly connected trailing cable. D Faulty carriage PCA. D Faulty electronics module. D K E L F M A G N B H O C I J Steady EKL Align Media + Cartridges + Data: Model ID not configured. D After replacing a new electronics module, it must be configured either as a DesignJet 430, 450C or 455CA. If a new module does not show this error, it means that it has been installed previously and was probably calibrated with other parameters. After configuring the module Error code Steady DLM will appear which means the accuracy calibration must be done. After the accuracy calibration is done, all other calibrations must be done. If configuring the module does not remove the error, even after switching the Printer OFF and ON, then the EEROM in the main PCA is probably defective. Before trying to replace the electronics module try clearing the EEROM and perform all the calibrations again and see if that solves the problem. Refer to page 4Ć27 in order to configure the correct model ID. For more information ' page 1Ć8. D K E L F M A G N B H O C I J Steady EK Align Media + Cartridges: EEROM test error. Possible causes: D Switch the Printer OFF and ON again and see if the error remains. If the error appears continuously, replace the Electronics Module. D The Calibrations in the EEROM have been lost. Perform the Accuracy Calibration (refer to Chapter 5). 2-8 HP DesignJet 430, 450C and 455CA Printers System Error Codes