HP 450c Service Manual - Page 66
Clearing Just the UserĆDefined Setup Parameters
View all HP 450c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Clearing the EEROM CAUTION If you clear the calibration parameters, you will then need to perform the Printer calibrations. (Details ' chapter 5.) Clearing the EEROM also resets the factory spittoon value to 0% used. Keep in mind that the value printed on the service configuration plot may greatly underestimate the amount of ink in the spittoon. Clearing Just the Benchrun and Calibration Parameters 1 Switch the Printer OFF. 2 While holding down the Form Feed, Cancel and Media Type keys down, switch the Printer ON. 3 Once the the LEDs begin to light up one by one, release the keys. Clearing Just the UserĆDefined Setup Parameters 1 Switch the Printer OFF. 2 While holding down the Reprint, Cancel, Media Type and Media Source keys down, switch the Printer ON. 3 Once the the LEDs begin to light up one by one, release the keys. 4-32 HP DesignJet 430, 450C and 455CA Printers Service Tests