HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 106

BOOTVAR Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message BOOTVAR-2-AUTOCOPY_FAILED: Autocopy of file [chars] to standby failed. [chars] (Error-id: [hex]) Explanation The image to be copied to standby vi the auto-copy feature failed. Recommended Action Check error id for specified reason. Error Message BOOTVAR-2-AUTOSYNC_FAILED: Image autosync failed. Reason: [chars] ([hex]) Explanation Image synchronization failed. Recommended Action Check that there is enough space on the flash, and check the system high availability status. Error Message BOOTVAR-2-CONFIG_ERROR: Failed to update boot configuration Explanation An error has occurred during the update of the boot configuration files. Recommended Action Check that there is enough space on the flash, enter the show boot command to check the configured image names, enter the show loader internal command to compare the configurations, if the configurations do not match, enter the write erase command and retry saving the configuration. Error Message BOOTVAR-2-IMAGE_NOT_COMPATIBLE: Warning: image [chars] is not compatible with the current platform in SUP [dec] Explanation The input image name is not compatible with the current platform. Recommended Action Make sure that the system has the correct image before you reboot. BOOTVAR-3 Error Message BOOTVAR-3-AUTOCOPY_FAILED_STANDBY_FULL: Autocopy of file [chars] to standby failed due to not enough disk space on standby Explanation There is not enough disk space on the standby for the file to be copied. Recommended Action Clear space on the standby disk. Error Message BOOTVAR-3-INIT_FAILED: Initialization failed: Component [chars] Explanation The system has detected that the service has failed to start. The failure occurs during initialization of the component [chars]. Recommended Action Enter the show processes command to check the status of the other processes, pay attention to the specified component. 2-68 Cisco NX-OS System Messages Reference OL-15994-03