HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 801

Chapter 2 System Messages and Recovery Procedures URIB Messages Send document comments to [email protected] Error Message URIB-2-RES_MGR Format: Error returned from %s, errno: 0x%08x (%s) in %s() Explanation The resource manager returned an error to URIB, while URIB was performing an action relating to its shared memory Parameters: RM Function, Error Code, Error Description, Calling Function ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message URIB-2-STARTUP_FAILURE Format: Startup failure: %s Explanation An unrecoverable software error has occurred during URIB startup. Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message URIB-2-TIMER_LIB Format: %s %s Explanation The timer library returned an error, causing an unrecoverable problem for URIB. Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. URIB-3 Error Message URIB-2-TOO_MANY_CLIENTS Format: %s client \%s\ Explanation URIB cannot add this client because the URIB client limit has already been reached. Parameters: Resource, Client ... Recommended Action Restart the component when the system is working. Error Message URIB-3-ADD_ERROR Format: Could not add %s/%d to the %s Explanation A error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message URIB-3-ADD_PATH_ERROR Format: %s: could not add path for client \%s\. Explanation A route add operation has failed for the given client. There may be a previous error message that further explains the problem. Parameters: Function, Client ... Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-763