HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 369
IVR-3
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 369 highlights
Chapter 2 System Messages and Recovery Procedures IVR Messages Send document comments to [email protected] Error Message IVR-2-PERSISTENT_VIRTUAL_FCID_CONFLICT_WITH_AUTOLEARN: Persistent virtual fcid and dynamic pfcid entries Explanation This can happen if conflict happens during persistent virtual domain, or virtual fcid entry configuration. Recommended Action Please assign a non-conflict persistent virtual domain or fcid entry with current dynamic entries. Error Message IVR-2-PERSISTENT_VIRTUAL_FCID_UNAVAILABLE: to vsan [dec] because the configured persistent virtual domain/fcid could not be assigned Explanation This can happen if the virtual domain/fcid configured by the user is - a) Already in use (either by IVR or a real switch) b) Not allowed due to interop mode or allowed domain list. Recommended Action Please make sure that the configured virtual domain/fcid is allowed and available for use. Error Message IVR-2-VIRTUAL_DOMAIN_CONFLICT: In VSAN [dec] virtual domain [dec] from native VSAN [dec] conflicts with native VSAN [dec] for the same virtual domain Explanation Currently advertised virtual domain [dec] in VSAN [dec] is native to VSAN [dec]. This switch has learned of a device that is member of active IVR zone and has the same domain ID, but belongs to a different native VSAN. This device would not be advertised in that VSAN until the domain conflict is resolved. Recommended Action No action is required. IVR-3 Error Message IVR-2-VIRTUAL_FCID_UNAVAILABLE: to vsan [dec] because the internally generated FCID conflicts with fcid assigned to WWN [chars]. Please configure fcid for WWN [chars] too Explanation This can happen if the virtual domain/fcid internally configured is already in use by another active device. Recommended Action Please assign a different persistent virtual fcid by command. Error Message IVR-3-AAM_MODE_CANNOT_CHANGE: AAM mode cannot be changed. Might cause the fabric NAT mode inconsistency Explanation The IVR NAT is not enabled. Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-331