HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 800
URIB Messages, URIB-2
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 800 highlights
URIB Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message UFDM-2-INTERNAL_ERROR: Internal error: [chars], collect output of show tech-support fowarding l3 unicast... command Explanation UFDM hit a internal error. Collect show tech-support forwarding l3 unicast for futher analysis. Recommended Action No action is required. URIB Messages This section contains the URIB messages. URIB-2 Error Message URIB-2-API_INIT_SEM Format: Failed to init the client API semaphore: open: %s, create: %s Explanation URIB could not create the semaphore that protects access to the shared memory between URIB and its clients. Parameters: Error from open, Error from create ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message URIB-2-BAD_PT Format: Possible Patricia tree corruption in %s Explanation An unrecoverable software error has occurred because of a bad route table. Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message URIB-2-NOPMEM Format: Failed to allocate private memory for %s Explanation URIB has run out of private memory. This condition can be caused by a temporary increase in the number of routes in the network, or a general network or router misconfiguration. Recommended Action Configure the network or router to decrease the number of routes, or add additional memory to the router. Error Message URIB-2-NOSMEM Format: Failed to allocate shared memory for %s Explanation URIB has run out of shared memory to store routes and related information. This condition can be caused by a temporary increase in the number of routes in the network, or a general network or router misconfiguration. Recommended Action Configure the network or router to decrease the number of routes, or reconfigure the shared memory through the following vdc mode commands: limit-resource u4route-mem min max limit-resource u6route-mem min max . 2-762 Cisco NX-OS System Messages Reference OL-15994-03