HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 787

Chapter 2 System Messages and Recovery Procedures U6RIB Messages Send document comments to [email protected] U6RIB-2 Error Message U6RIB-2-API_INIT_SEM Format: Failed to init the API semaphore: open: %s, create: %s Explanation U6RIB could not create the semaphore that protects access to the shared memory between U6RIB and its clients. Parameters: Error from open, Error from create ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message U6RIB-2-NOPMEM Format: Failed to allocate private memory for %s Explanation U6RIB has run out of private memory. This condition can be caused by a temporary increase in the number of routes in the network, or a general network or router misconfiguration. Recommended Action Configure the network or router to decrease the number of routes, or add additional memory to the router. Error Message U6RIB-2-NOSMEM Format: Failed to allocate shared memory for %s Explanation U6RIB has run out of shared memory to store routes. This can be caused by a temporary increase of the number of routes in the network, or a general network or router misconfiguration. Recommended Action Configure the network or router to decrease the number of routes, or reconfigure the shared memory through the following vdc mode commands: limit-resource u4route-mem min max limit-resource u6route-mem min max . Error Message U6RIB-2-RES_MGR Format: Error returned from %s, errno: 0x%08x (%s) in %s() Explanation The resource manager returned an error to U6RIB, while U6RIB was performing an action relating to its shared memory Parameters: RM Function, Error Code, Error Description, Calling Function ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message U6RIB-2-STARTUP_FAILURE Format: Startup failure: %s Explanation An unrecoverable software error has occurred during u6RIB startup. Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. OL-15994-03 Cisco NX-OS System Messages Reference 2-749