HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 260
Flogi-2, Flogi-4
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
FLOGI Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message FLOGI-1-MSG_FLOGI_REJECT_FCID_ERROR: [VSAN [dec], Interface [chars]] FLOGI rejected - FCID allocation failed. Explanation An FLOGI was rejected because the FCID allocation failed. Recommended Action Check the fcid-interop configuration, purge the persistency table and check the output of show flogi database details and see if any of the A area FCID allocation entries can be configured to single fcid allocation as per Configuration Guide. Error Message FLOGI-1-MSG_FLOGI_REJECT_TOO_MANY_LOGINS: [VSAN [dec], Interface [chars]] FLOGI rejected - this interface has reached the max num of NL-Ports ([dec]) Explanation An FLOGI was rejected because the FL-Port has reached the maximum allowed number of devices. Recommended Action Reduce the number of devices on the loop. FLOGI-2 Error Message FLOGI-1-MSG_NPIV_NOT_SUPPORTED_WITH_TRUNKING: [VSAN [dec], Interface [chars]] NPIV not supported - on this platform, NPIV is not supported on trunking interfaces Explanation The N_Port requested NPIV, but this platform does not support NPIV on trunking F_Ports. Recommended Action Disable NPIV, or move the N_Port to a switch that supports NPIV on trunking F_Ports. FLOGI-4 Error Message FLOGI-2-MSG_FLOGI_REJECT_NO_ACL_TCAM_AVAILABLE: [VSAN [dec], Interface [chars]] FLOGI rejected - ACLTCAM resource exausted Explanation An FLOGI was rejected because the ACLTCAM hardware resource is completely used. Recommended Action Reduce the number of nodes. Error Message FLOGI-4-MSG_VF_FLOGI_FROM_NON_CISCO_OUI: [VSAN [dec], Interface [chars]] FLOGI with VF bit set from OUI [hex]:[hex]:[hex] (nwwn: [chars]) Explanation This interface received an FLOGI with VF bit set from a nonCisco OUI; in this release Virtual Fabrics are not supported on interfaces connected to third-party devices. Recommended Action Set the trunk mode of this interface to off. 2-222 Cisco NX-OS System Messages Reference OL-15994-03