HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 844

VRRP-ENG Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message VRRP-CFG-5-VR_DELETED: VR [chars]group [dec] removed from interface [chars] Explanation The specified VRRP group has been successfully deleted on interface [chars]. Recommended Action No action is required. VRRP-ENG Messages This section contains the VRRP-ENG messages. VRRP-ENG-2 Error Message VRRP-ENG-2-ALLOC_MEMORY: Memory allocation failed Explanation The service failed to allocate a block of dynamic memory. Recommended Action No action is required. Error Message VRRP-ENG-2-INVALID_CONFIG: Cannot start the VR[chars] [dec] on the interface [chars]. Invalid IP configuration. Reason: [chars] Explanation The specified VR on interface [chars] is enabled but the IP configuration is not valid because of [chars]. Recommended Action Show interface to check that the IP address of the interface is configured and it is in the same subnet of the virtual router address. Error Message VRRP-ENG-2-VR_FAILURE: Error in VR[chars] [dec] interface [chars]. Going to init state Explanation The VR [dec] on the interface [chars] is in init state for an internal error. Recommended Action Show interface to check the status of the interface, show configuration, status and statistics of the specified virtual router, enable the VRRP debug and shut/ no shut the specified virtual router. VRRP-ENG-3 Error Message VRRP-ENG-3-INIT_FAILED: Initialization failed. Component [chars] Explanation The system has detected that the service has failed to start. The failure occurred while initializing the component [chars]. Recommended Action Enter the show processes command to check the status of the other processes, debug the specified component. 2-806 Cisco NX-OS System Messages Reference OL-15994-03