HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 206

ETHPORT Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message ETHPORT-2-IF_DOWN_ERROR_DISABLED: Interface [chars] is down (Error disabled. Reason:[chars]) Explanation The system has detected that the interface has has detected an error during the configuration. Recommended Action Collect more information about the failed interface using the command 'show port internal all interface [char]'. In most cases, you can recover using a 'shutdown' followed a 'no shutdown' on the interface or remove and reinsert the fiber optic cable. Error Message ETHPORT-2-IF_SEQ_ERROR: Error ([chars]) while communicating with component [chars] for opcode [chars] ([chars]) Explanation A component has system error as a response to a port event sequence. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message ETHPORT-2-IF_SEQ_ERROR: Error ([hex]) while communicating with component [chars] opcode:[chars] (for:[chars]) Explanation A component did not respond to a request in a stipulated time. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message ETHPORT-2-SEQ_TIMEOUT: Component [chars] timed out on response to opcode [chars] ([chars]) Explanation A component did not respond to a request in a stipulated time. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message ETHPORT-2-SEQ_TIMEOUT: Component [chars] timed out on response to opcode:[chars] (for:[chars]) Explanation A component did not respond to a request in a stipulated time. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. 2-168 Cisco NX-OS System Messages Reference OL-15994-03