HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 679

Chapter 2 System Messages and Recovery Procedures SVC Messages Send document comments to [email protected] Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_NO_FABRIC ) The node is unable to see the FC fabric [chars] Explanation No active/functioning logical FC port was detected by the software. Recommended Action Reload the node. If the problem persists, replace the Caching Services Module. Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_PWR_DMN_ERR ) Power domain error [chars] Explanation The two nodes in an IO group are on the same Caching Services Module. Recommended Action Determine if both nodes on the Caching Services Module are in fact in the same IO group. If so, determine what the configuration should be. Remove one of the nodes and add a node to the IO group which is not on the same Caching Services Module. If not, ask IBM Product Support for assistance. Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_REPEATED_ASSERTS ) Node repeatedly crashing due to a software fault [chars] Explanation The number of software faults has exceeded the maximum allowed for the time period. Recommended Action 1. Delete the node from the cluster. 2. Try to add the node back into the cluster. 3. Ensure that the software is at the latest level on the cluster. If not, upgrade the cluster with the latest level of code. 4. If the error continues, ask IBM Product Support for assistance. Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_RESET_AND_REJECT ) Node data not found - node rejected from cluster [chars] Explanation Node data was not found. The node has been rejected from the from cluster. Recommended Action Examine error logs to determine if another recorded error caused the loss of the node data and, if so, follow the actions for that error. If no other error was recorded, the node may have lost power without saving data or been reset. Attempt to determine the cause of the power loss or reset. If no cause can be determined, then: 1. Re-install the code on the node. The node will have to be removed and re-added back to the cluster. 2. Ensure that the software is at the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1 with the latest level of code. 3. If the error continues, ask IBM Product Support for assistance. It may be necessary to replace the Caching Services Module. Error Message SVC-3-NODE_ERR_MSG: [chars] Explanation Syslog message from a SVC interface node. Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-641