HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 193

Chapter 2 System Messages and Recovery Procedures ETH-PORT-SEC Messages Send document comments to [email protected] EPP-5 Error Message EPP-5-EPP_FAILURE: Interface [chars] EPP Failure Explanation Trunk protocol failed. Recommended Action 'show epp internal event-history error' will indicate the errors encountered. Error Message EPP-5-EPP_LOOPBACK: Interface [chars] is looped back to the same switch Explanation The interface is looped back to another interface on the same switch. Recommended Action Check the connectivity of this interface and ensure that it is connected to another switch. ETH-PORT-SEC Messages This section contains the ETH-PORT-SEC messages. ETH-PORT-SEC-2 Error Message ETH-PORT-SEC-2-ETH_PORT_SEC_SECURITY_VIOLATION_ANOTHER_PORT: Host [chars] bound to Port [chars] in Vlan [dec] is trying to access Port [chars] in Vlan [dec] Explanation The port is in a violation state because a MAC address that was seen on one port has been seen on another port too. Recommended Action No action is required. Error Message ETH-PORT-SEC-2-ETH_PORT_SEC_SECURITY_VIOLATION_MAX_MAC_VLAN: Port [chars] moved to [chars] state as host [chars] is trying to access the port in vlan [dec] Explanation The port is in a violation state due to an exceeding address count. Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-155