HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 109

Chapter 2 System Messages and Recovery Procedures CALLHOME Messages Send document comments to [email protected] BOOTVAR-6 Error Message BOOTVAR-6-ALREADY_IN_SYNC: Image already in sync Explanation This message indicates that you do not need to update the image on the standby supervisor module. Recommended Action No action is required. Error Message BOOTVAR-6-CONFIG_UPDATED: Boot configuration updated Explanation The boot-loader configuration files have been successfully updated. Recommended Action No action is required. Error Message BOOTVAR-6-STARTING: Boot configuration initialized Explanation The service has successfully started. Recommended Action No action is required. CALLHOME Messages This section contains the CALLHOME messages. CALLHOME-2 Error Message CALLHOME-2-EVENT: [chars] Explanation A Call Home event [chars] occurred. Recommended Action If you have configured your e-mail address to receive Call Home notifications, check your e-mail for more details about this Call Home event. If Call Home was not enabled, execute commands relevant to the callhome event to get more information about the error. Error Message CALLHOME-2-PROGRAM_EXIT: callhome process ending: [chars] Explanation A Call Home process is exiting with the reason [chars]. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. OL-15994-03 Cisco NX-OS System Messages Reference 2-71