HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 108
standby supervisor to load the new image.
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
BOOTVAR Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message BOOTVAR-5-AUTOCOPY_VERIFY_SEND_FAILED: Unable to ask standby to verify file [chars], error = [hex] Explanation When the image was copied to the standby supervisor module, the system failed to ask the standby supervisor module to verify the integrity of the image. Recommended Action Turn auto-copy off and back on. Error Message BOOTVAR-5-AUTOSYNC_DONE: Image autosync done Explanation The image synchronization was successful. Recommended Action No action is required. Error Message BOOTVAR-5-AUTOSYNC_REBOOT: Rebooting standby after successful autosync Explanation The image autosynchronization has been successful. The system is resetting the standby supervisor to load the new image. Recommended Action Check that the standby supervisor module reloads correctly. Error Message BOOTVAR-5-AUTOSYNC_START: Starting image autosync. Please wait until completion... Explanation The standby supervisor module has requested the synchronizationof the current image. Recommended Action No action is required. Error Message BOOTVAR-5-IMAGE_NOTEXISTS: Warning: image [chars] doesn't exist on sup[dec] Explanation The input image name does not exist on the specified supervisor. Recommended Action Check whether the input image name you entered exists and make sure that you have the image on the flash before you reboot. Error Message BOOTVAR-5-NEIGHBOR_UPDATE_AUTOCOPY: auto-copy supported by neighbor supervisor, starting... Explanation The information log reports that the standby supervisor module supports autocopy. Autocopy is being started. Recommended Action No action is required. 2-70 Cisco NX-OS System Messages Reference OL-15994-03