HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 716
Use the command 'reload module <mod>' to reset the standby supervisor if you, want to try again.
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 716 highlights
SYSMGR Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message SYSMGR-2-GSYNC_FAILED_ACTIVE: global sync failed for UUID [hex] Explanation Gsynchronizationctrl on active has failed. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message SYSMGR-2-GSYNC_FAILED_STDBY: standby fails due to gsync failure on [chars] Explanation Standby fails/resets due to gsynchronization failure. Recommended Action Use the command 'reload module ' to reset the standby supervisor if you want to try again. Error Message SYSMGR-2-GSYNC_GET_TIMEOUT: Request for global sync for UUID [hex] not completed in specified time. Explanation Service failed to complete global synchronizationin specified time. The standby will no longer act as a HA standby. Recommended Action If the problem persists, please contact customer support. Error Message SYSMGR-2-GSYNC_READY_SRVFAILED: Service [chars] on standby supervisor failed to restore its snapshot (error-id [hex]). Explanation The initial synchronization of service [chars] has failed. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message SYSMGR-2-GSYNC_SNAPSHOT_SRVFAILED: Service [chars] on active supervisor failed to store its snapshot (error-id [hex]). Explanation The initial synchronization of service [chars] has failed. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message SYSMGR-2-HANDSHAKE_FAILED: Handshake with service [chars] in vdc [dec] failed since send failed: [chars] (error-id [hex]). Explanation Handshake with a service failed since system manager could not send handshake response to it. Recommended Action No action is required. 2-678 Cisco NX-OS System Messages Reference OL-15994-03