HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 793

Chapter 2 System Messages and Recovery Procedures U6RIB Messages Send document comments to [email protected] Error Message U6RIB-3-RNH_LOOP_ERROR Format: Number of prefixes forming rnh loop exceeds %d\n Flagging route %s/%d from client \%s\ with nh %s, rnh %s/%d\n as causing rnh loop Explanation U6RIB detected a loop between routes installed in the RIB. Check the message to see which client caused the loop, and take appropriate ation. Parameters: Max RNH Loop, Prefix, Prefix Length, Client, Next-hop, Prefix, Prefix Length ... Recommended Action Requires operator to intervene. Error Message U6RIB-3-RPM_LIB_ERROR Format: %s %d Explanation An RPM library function returned an error. Parameters: Function, RPM Error Code ... Recommended Action No action is required. Error Message U6RIB-3-SDWRAP_LIB_ERROR Format: %s %s Explanation A SDWrap library function returned an error. Parameters: Function, SDWrap Error Code ... Recommended Action No action is required. Error Message U6RIB-3-SEND_TO_ERROR Format: Send to u6rib failed: %s Explanation The calling process was unable to send a message to U6RIB. Recommended Action Use the 'restart' command to restart the feature and clear this problem. Error Message U6RIB-3-STRUCT_ERROR Format: Structural error: %s, client \%s\, table id 0x%08x. Explanation A severe data structural error was encountered. The system may run into more errors because of this problem. Parameters: Problem, Client, Table id ... Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message U6RIB-3-TABLE_CREATE_ERROR Format: Failed to create table info for VRF %s for client \%s\ Explanation U6RIB could not create its table data structure for the VRF being created. There may be further errors that indicate the failure in more detail. The shown VRF should be reconfigured in the system. i.e. in global configuration, 'no vrf context ' Parameters: VRF, Client ... Recommended Action Requires operator to intervene. OL-15994-03 Cisco NX-OS System Messages Reference 2-755