HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 427
The xbar in slot [decimal digit] reported a failure in the runtime diagnostic. Module
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 427 highlights
Chapter 2 System Messages and Recovery Procedures MODULE Messages Send document comments to [email protected] Error Message MODULE-2-MOD_SOMEPORTS_FAILED: Module [dec] (serial: [chars]) reported failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]) Explanation Module [decimal digit] reported a failure in the runtime diagnostic due to failure in some of the ports. Recommended Action Collect information about the module by issuing the command 'show module internal all module [decimal digit]'. Error Message MODULE-2-MOD_UNKNOWN: Module type [[dec]] in slot [dec] is not supported Explanation The software card id of module [decimal digit] is not supported by the supervisor. Recommended Action Collect information about the module by issuing the commands 'show module internal all module [decimal digit]'. Error Message MODULE-2-XBAR_DIAG_FAIL: Xbar [dec] (serial: [chars]) reported failure [chars] due to [chars] in device [dec] (device error [hex]) Explanation The xbar in slot [decimal digit] reported a failure in the runtime diagnostic. Module manager is going to power cycle the module. Recommended Action Collect information about the module by issuing the command 'show module internal all xbar [decimal digit]'. Error Message MODULE-2-XBAR_FAIL: Initialization of xbar [dec] (serial: [chars]) failed Explanation Xbar [decimal digit] reported a failure during the initialization phase and will be powered down. Recommended Action Collect information about the module by issuing the commands 'show module_internal all xbar '. Error Message MODULE-2-XBAR_SOMEPORTS_FAILED: Xbar [dec] (serial: [chars]) reported failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]) Explanation Xbar [decimal digit] reported a failure in the runtime diagnostic due to failure in some of the ports. Recommended Action Collect information about the module by issuing the command 'show module internal all xbar [decimal digit]'. OL-15994-03 Cisco NX-OS System Messages Reference 2-389