HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 85

Chapter 2 System Messages and Recovery Procedures BGP Messages Send document comments to [email protected] BGP-3 Error Message BGP-3-ACLTESTADD Format: Failed to add %s peer policy test Explanation An internal software error occurred. Parameters: ACL type ... Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message BGP-3-AGGADD Format: [%s] Couldn't add aggregate for %s/%d Explanation BGP was unable to store an aggregate in an internal datastructure. The BGP process may have run out of memory. Recommended Action If BGP ran out of memory, add memory to the router or change the network configuration to decrease memory requirements. Clear any BGP peers that may have been shut down automatically. If BGP has available memory, restart BGP. Error Message BGP-3-AGGDEL Format: [%s] Couldn't delete aggregate for %s/%d Explanation An unexpected but recoverable event has occurred. Parameters: Address-family, Prefix/masklength ... Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message BGP-3-ALLOCFAIL Format: %s malloc (%ld) failed for: %s Explanation The system may be low on memory. Parameters: Alloc Type, Size, Error ... Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message BGP-3-API_UNEXP_RESP Format: Received unexpected message from SAP %d, opcode %d, address %s, ignore it Explanation An unexpected but recoverable event has occurred. Parameters: MTS SAP, MTS Opcode, IP Address ... Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-47