HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 213

Chapter 2 System Messages and Recovery Procedures ETHPORT Messages Send document comments to [email protected] Error Message ETHPORT-5-IF_DOWN_LOOPBACK_DIAG_FAILURE: Interface [chars] is down (Diag failure) Explanation The diagnostics failed on the interface. Recommended Action Collect more information about the failed interface using the command 'attach module' to connect to the module. Error Message ETHPORT-5-IF_DOWN_LOOPBACK_ISOLATION: Interface [chars] is down (Isolation due to port loopback to same switch) Explanation The interface is looped back to another interface on the same switch. Recommended Action Check the connectivity of this interface and ensure that it is connected to another switch. Error Message ETHPORT-5-IF_DOWN_MODULE_REMOVED: Interface [chars] is down (module removed) Explanation The system has detected that an interface is down because the module was removed. Recommended Action No action is required. Error Message ETHPORT-5-IF_DOWN_NON_PARTICIPATING: Interface [chars] is down (Non participating) Explanation The loop port has been put into nonparticipating mode. Recommended Action No action is required. Error Message ETHPORT-5-IF_DOWN_NONE: Interface [chars] is down (None) Explanation There is no apparent reason the interface is down. Recommended Action Collect more information about the port using the command 'show port internal info/event-history' to determine why it went down. Error Message ETHPORT-5-IF_DOWN_OFFLINE: Interface [chars] is down (Offline) Explanation The interface has been placed into the offline state. Recommended Action No action is required. Error Message ETHPORT-5-IF_DOWN_PARENT_ADMIN_DOWN: Interface [chars] is down (Parent interface down) Explanation Parent interface is down. Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-175