HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 265
Fspf-4
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 265 highlights
Chapter 2 System Messages and Recovery Procedures FSPF Messages Send document comments to [email protected] Error Message FSPF-3-UNLOCK_FAIL: FSPF failure in releasing lock Explanation There is a software failure in releasing lock of the shared resource between FSPF threads. Recommended Action Provide output of 'debug fspf all '. FSPF-4 Error Message FSPF-3-VSAN_TIMER_ERR: Error in processing VSAN timer event [chars], error description = [chars] Explanation FSPF had an internal error in processing timer event , error description is [chars]. Recommended Action Provide output of 'debug fspf error'. Error Message FSPF-4-FC2_DOWN_INTF: Received FC2 packet on DOWN interface [chars] Explanation FSPF received a FC2 packet on inactive interface [chars] . Recommended Action This message may be printed for the first FSPF packet when an interface is brought up. If the message is seen continuously check if FSPF is disabled on one end for the interface or the VSAN. Otherwise check 'show interface ' output to see if interface is physically up only on one side. Also check if there is any error message printed for IPC_PROC_ERR. Error Message FSPF-4-FC2_DOWN_VSAN: Received FC2 packet on inactive vsan Explanation FSPF received a FC2 packet on inactive VSAN. Recommended Action If message seen continuously check if FSPF is disabled on the VSAN Investigate if VSAN is active and valid domain has been assigned on the switch Also check if IPC_PROC_ERR message is printed in the syslog. Error Message FSPF-4-ILLEGAL_FSM_EVENT: Illegal FSM event for state [chars] in interface [chars] Explanation An illegal protocol event has occurred for the FSPF state machine. The old state was [chars] for the interface [chars]. Recommended Action It is possible to get this message if some protocol packet gets dropped but the system should recover and move back to FULL state. Do 'show fspf interface' to check the state of the interface. If it is stuck in state other than FULL provide output of 'debug fspf event' and 'debug fspf fc pkt ' for the interfaces involved. OL-15994-03 Cisco NX-OS System Messages Reference 2-227