HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 362

ISIS Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message ISIS-4-LSPFULL_FORCED_DROP Format: L%d %s LSP is full, removed lower priority TLVs to make room for type %d TLV Explanation There was no storage space left for important routing information in the router\sLSP,andsolowerpriorityinformation(e.g.,redistRIButedprefixes)hasbeendroppedtomakeroo m.' Parameters: Level, LSP Type, TLV Type ... Recommended Action Configure IS-IS so that less information will be distRIButed in the router's LSP, for example by reducing redistRIButed prefixes. Error Message ISIS-4-NO_CID Format: Cannot allocate CID for %s\n - Over 255 LANs limit Explanation IS-IS has been enabled on more than 255 broadcast interfaces and thus exceeded the protocol mandated limitation. Interfaces that are enabled beyond 255 will be igored internally until the total count drops below 255. Parameters: Interface Name ... Recommended Action Disable IS-IS on one or more broadcast interfaces using the command no ip router isis, or convert the interface to point-to-point mode. using the command medium p2p followed by ip router isis. Error Message ISIS-4-NO_MEM Format: No memory event detected Explanation An attempt to allocate from free memory failed. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message ISIS-4-P2P_DUP_SYSID Format: P2P IIH - Duplicate system ID %s detected over %s Explanation IS-IS has detected another system on the indicated P2P that is reusing the local system ID. Parameters: The system ID, Interface Name ... Recommended Action Configure either the local or remote router with a different system ID using the command net. Error Message ISIS-4-PROC_NO_MEM Format: No memory event, shutting down process Explanation Previously an allocation failed due to no available memory. IS-IS will shut down and wait for user to restart it. Recommended Action Use the 'restart' command to restart the feature and clear this problem. 2-324 Cisco NX-OS System Messages Reference OL-15994-03