HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 809
The value provided is outside of the acceptable range., of this problem.
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 809 highlights
Chapter 2 System Messages and Recovery Procedures URIB Messages Send document comments to [email protected] Error Message URIB-3-PTDEL_ERROR Format: Could not delete %s/%d from the URIB pt, error code %d Explanation A severe route table error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message URIB-3-QADD_ERROR Format: Could not add %s to the %s queue Explanation A severe queue error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message URIB-3-RANGE_CHECK_ERR Format: Range check of %s failed from %s (0x%08x) Explanation The value provided is outside of the acceptable range. Parameters: Range, Provider of value, Value Provided ... Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message URIB-3-RNH_LOOP_ERROR Format: Number of prefixes forming rnh loop exceeds %d\n Flagging route %s/%d from client \%s\ with nh %s, rnh %s/%d\n as causing rnh loop Explanation URIB detected a loop between routes installed in the RIB. The message shows which client caused the loop. Parameters: Max RNH Loop, Prefix, Prefix Length, Client, Next-hop, Prefix, Prefix Length ... Recommended Action Requires operator to intervene. Error Message URIB-3-RPM_LIB_ERROR Format: %s %d Explanation An RPM library function returned an error. Parameters: Function, RPM Error Code ... Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-771