HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 808
URIB called a PSS API which returned an error. The error reported should be examined, for the cause.
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 808 highlights
URIB Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message URIB-3-NO_L3VM_INFO_ERROR Format: no L3VM info for table id 0x%08x from client \%s\ - unknown to L3VM Explanation A client tried to add some information to URIB and provided a Table-Id that is unknown in the system. The client should be restarted. Parameters: Table-Id Client name ... Recommended Action Use the 'restart' command to restart the feature and clear this problem. Error Message URIB-3-NOT_INIT_L3VM_ERROR Format: L3VM info for table id 0x%08x from client \%s\ not available - URIB not initialised with L3VM Explanation A client tried to add some information to the URIB, before URIB has registered for the table information. The client should be restarted. Parameters: Table-Id, Client name ... Recommended Action Use the 'restart' command to restart the feature and clear this problem. Error Message URIB-3-OPEN_CLIENT_SHM_ERROR Format: Failed to open client shared memory \%s\: %s Explanation The calling process failed with the shown error while trying to open the named URIB shared memory region. The status of the memory is shown in 'show process memory shared'. Parameters: Name of shared memory region ... Recommended Action Use the 'restart' command to restart the feature and clear this problem. Error Message URIB-3-PSS Format: Error returned from %s, errno: 0x%08x (%s) in %s() Explanation URIB called a PSS API which returned an error. The error reported should be examined for the cause. Parameters: Failed API, Error Code, Error Description, URIB Function ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message URIB-3-PTADD_ERROR Format: Could not add %s/%d to the %s pt, error code %d Explanation A severe route table error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. 2-770 Cisco NX-OS System Messages Reference OL-15994-03