HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 807
The size of a URIB message is incorrect for the type of message. The message is
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 807 highlights
Chapter 2 System Messages and Recovery Procedures URIB Messages Send document comments to [email protected] Error Message URIB-3-MTS_REGISTER Format: mts_register failed for urib: %s Explanation URIB was unable to register client for URIB notifications, causing an unrecoverable error. Recommended Action Use the 'restart' command to restart the feature and clear this problem. Error Message URIB-3-MTS_SHORT_MSG_ERROR Format: Received short (%d < %d) MTS message on %s queue with opcode %d, dropping it Explanation URIB received an unknown message. The message is dropped. Recommended Action No action is required. Error Message URIB-3-MTS_SIZE_ERROR Format: %s: incorrect %s message size from client %s: %d (should be %d) Explanation The size of a URIB message is incorrect for the type of message. The message is dropped. Recommended Action No action is required. Error Message URIB-3-MTS_UBIND Format: mts_unbind failed for %s: %s Explanation URIB was unable to unbind from an MTS queue SAP, causing an unrecoverable error. Parameters: MTS queue name, Error ... Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message URIB-3-NH_RESOLV_ADD_ERROR Format: Could not add %s/%d to the %s (%d) resolve buffer Explanation A error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message URIB-3-NHLFE_DEL_ERROR Format: Could not find nhlfe for %s/%d via %s%%%s, client \%s\ Explanation Next-hop had a NHLFE, but could not delete it while deleting the Next-hop. Parameters: Prefix, Prefix Length, Next-hop, Interface, Client ... Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-769