HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 715
during boot., If the problem persists, please use the vshboot command 'init system'
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 715 highlights
Chapter 2 System Messages and Recovery Procedures SYSMGR Messages Send document comments to [email protected] Error Message SYSMGR-2-CONVERT_ZIPPING_FAILED: Failed to zip the converted startup configuration. Explanation This message indicates that conversion of the startup configuration failed when system was trying to zip the converted configuration. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message SYSMGR-2-CORE_SAVE_FAILED: [chars]: PID [dec] with message [chars]. Explanation The system has detected an error. Recommended Action No action is required. Error Message SYSMGR-2-CREATE_DONEFILE_FAILED: Creating /var/run/sysmgr.initdone failed with return value: ([dec]). Explanation The initialization of the system could not complete. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message SYSMGR-2-DELETE_BINARY_STARTUP_FAILED: Deletion of binary startup config failed during boot (error-id [hex]). Explanation This message indicates that the deletion of the binary startup configuration failed during boot. Recommended Action If the problem persists, please use the vshboot command 'init system' to initialize the configuration partition. Error Message SYSMGR-2-FORMAT_FAILURE_SUP_RESET: Failure to format a partition successfully causing sup to reset. Explanation The partition used to store non-volatile pss files could not be formatted successfully. The supervisor will be reset. Recommended Action If the problem persists, please contact customer support. Error Message SYSMGR-2-GSYNC_ABORT: Global sync aborted by signal. Explanation The initial synchronization of the services has been aborted. The synchronization will be attempted again later. Recommended Action Use the command 'reload module ' to reset the standby supervisor if you want to try again. OL-15994-03 Cisco NX-OS System Messages Reference 2-677