HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 795

Chapter 2 System Messages and Recovery Procedures U6RIB Messages Send document comments to [email protected] Error Message U6RIB-4-UFDM_ACKNOT_FOUND Format: Could not find UFDM buffer with ptr 0x%08x Explanation Ack received for a UFDM buffer that U6RIB does not know about. Parameters: Memory address of UFDM buffer ... Recommended Action No action is required. U6RIB-5 Error Message U6RIB-5-API_INIT_SEM_CLEAR Format: Cleared the API semaphore from %d Explanation The API semaphore was in an unexpected state, and was restored to a correct value. Parameters: Value of semaphore ... Recommended Action No action is required. Error Message U6RIB-5-CLT_EVENT_STATE Format: Client \%s\ unexpected %s event state %d != %d Explanation An unexpected but recoverable event has occurred. Recommended Action No action is required. Error Message U6RIB-5-CLT_NO_BUF Format: Client \%s\ %s event has no buffer Explanation An unexpected but recoverable event has occurred. Recommended Action No action is required. Error Message U6RIB-5-DUP_REGISTER Format: Client \%s\ register more than once with same pid Explanation A client tried to register more than once with U6RIB. The re-registration was igored. Recommended Action No action is required. Error Message U6RIB-5-GENERAL_FAILURE Format: Failed to %s Explanation The logged action failed. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. OL-15994-03 Cisco NX-OS System Messages Reference 2-757