HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 674

SVC Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_IO_TIMEOUT_OVERALL ) Timeout due to excessive processing time [chars] Explanation A managed disk has timed out. This error has been reported because a large number of disk timeout conditions have been detected. The problem is probably caused by a failure of some other component on the SAN. Recommended Action 1. Repair problems on all disk controllers and switches on the same SAN as this cluster. 2. If problems are found, mark this error as fixed. 3. If no switch or disk controller failures can be found, take an error log dump and call your hardware support center. Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_LOCAL_PORT_EXCLUDED ) Local FC port excluded [chars] Explanation A local fibre-channel port has been excluded. Recommended Action 1. Repair the fibre-channel network fabric. 2. Check the status of the disk controller. 3. If all disk controllers show good status, mark the error you have just repaired as fixed. 4. If the error persists and no other cause can be determined, replace the Caching Services Module. Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_LOGIN_EXCLUDED ) Login excluded [chars] Explanation Login has been excluded. Recommended Action 1. In the sequence shown, exchange the FRUs for new FRUs: Fibre Channel cable, switch to remote port. 2. Start a cluster discovery operation to recover the login. 3. Check the status of the disk controller. If all disk controllers show a good status, mark the error you have just repaired as fixed. 4. If the error persists and no other cause can be determined, replace the Caching Services Module. Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_LUN_RESOURCE_RAN_OUT ) Too many LUNs were presented to a node [chars] Explanation The configuration is not valid. Too many devices have been presented to the cluster or node. Recommended Action 1. Remove unwanted devices from the fibre-channel network fabric. 2. Start a cluster discovery operation to find devices. 3. List all connected managed disks. Check that the configuration is as expected. Mark the error you have just repaired as fixed. 2-636 Cisco NX-OS System Messages Reference OL-15994-03