HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 167

Chapter 2 System Messages and Recovery Procedures DOT1X Messages Send document comments to [email protected] Error Message DOT1X-3-NOT_DOT1X_CAPABLE: interface [chars] because it is not a physical Ethernet interface. Explanation Dot1x Authentication can only be enabled on physical Ethernet interfaces. Recommended Action Enable Dot1x Authentication on physical Ethernet interfaces only. DOT1X-4 Error Message DOT1X-3-SM_INIT: Internal error while initializing state machine [chars], state [chars]: [chars] Explanation An attempt was made to initialize an invalid state machine. Recommended Action Initialize dot1x state machine. Error Message DOT1X-4-BADEVENT: Event [chars] is invalid for the current state [chars]: [chars] [chars] Explanation An attempt was made to post an event to a state machine that is invalid for the current state. Recommended Action Initialize dot1x state machine. Error Message DOT1X-4-MAB_DISABLED: Interface [chars] is in Trunk mode, MAB is not supported on this port Explanation MAB is not supported on Trunk port. Recommended Action To enable MAB make sure that port is not in trunk mode. Error Message DOT1X-4-MAB_DISABLED: Interface [chars] is in Trunk mode, MAB will be disabled on this port Explanation MAB is not supported on Trunk port. Recommended Action To enable MAB make sure that port is not in trunk mode. Error Message DOT1X-4-MAB_DISABLED_ON_PCM: Interface [chars] is a member of portchannel, MAB is not supported on this port Explanation MAB is not supported on port channel member port. Recommended Action To enable MAB make sure that port is not member of port channel. OL-15994-03 Cisco NX-OS System Messages Reference 2-129