HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 802

URIB Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message URIB-3-ASSERT_ERROR Format: %s:%d: Assertion \%s\ failed. Explanation An internal software error has occurred. An assertion held to be true failed. Parameters: Filename, Line number, Expression ... Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message URIB-3-AVLADD_ERROR Format: Could not add %s (0x%08x) to the %s avl Explanation URIB was unable to add a piece of data to an AVL data structure. Parameters: Data item, Memory address, Data structure ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message URIB-3-AVLINIT_ERROR Format: Could not init %s avl for VRF %s Explanation URIB was unable to correctly initialize an AVL data structure. Parameters: AVL name, VRF-name ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message URIB-3-CMI_MTSSEND_FAILURE Format: mts_send failure for client %s: %s Explanation URIB was unable to send an MTS message to a particular client Parameters: Client name, Error ... Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' CLI command. Error Message URIB-3-CMI_PAYLOAD_CONV_ERR Format: CMI payload conversion error failure from %s order to %s order Explanation The cmi payload conversion did not occur successfully. Parameters: order, order ... Recommended Action No action is required. Error Message URIB-3-COPY_ERROR Format: Could not copy %s for %s/%d Explanation A error was encountered during route optimization. The system may run into more errors because of this problem. Recommended Action No action is required. 2-764 Cisco NX-OS System Messages Reference OL-15994-03