HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 215
The src interface with ip address that matches the ip address of the bound
View all HP Cisco Nexus 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Chapter 2 System Messages and Recovery Procedures ETHPORT Messages Send document comments to [email protected] Error Message ETHPORT-5-IF_DOWN_SOFTWARE_FAILURE: Interface [chars] is down (Port software failure) Explanation The software servicing the data path on the port has failed. Recommended Action No action is required. Error Message ETHPORT-5-IF_DOWN_SRC_MOD_NOT_ONLINE: Interface [chars] is down(Tunnel source module not online) Explanation Module that has the tunnel source port of this FCIP interface is not fully online. Recommended Action The module that has the tunnel src port is coming online. Enter the show module command to find the module status. Error Message ETHPORT-5-IF_DOWN_SRC_PORT_NOT_BOUND: Interface [chars] is down (Tunnel port src interface unbound) Explanation Tunnel port source interface unbound. Recommended Action No action is required. Error Message ETHPORT-5-IF_DOWN_SRC_PORT_REMOVED: Interface [chars] is down(Tunnel src port removed) Explanation Tunnel source port of this FCIP interface has been removed. Recommended Action The src interface with ip address that matches the ip address of the bound entity is removed. This happens normally due to the module on which the src interface exists is removed. Error Message ETHPORT-5-IF_DOWN_SUSPENDED: Interface [chars] is down (Suspended) Explanation This interface belongs to a port channel and has been suspended due to an error while bringing it up. Recommended Action Perform a 'shutdown' and a 'no shutdown'. If this happens again obtain output of 'show port internal info/event-history' on the interface. Error Message ETHPORT-5-IF_DOWN_SUSPENDED_BY_MODE: Interface [chars] is down (Suspended due to incompatible mode) Explanation This interface belongs to a port channel and operational mode of the interface is different from that of the port channel. Recommended Action Change the mode and the trunking mode of the port channel from 'auto' and check to ensure that the remote end of the interface also belongs to the same port channel. OL-15994-03 Cisco NX-OS System Messages Reference 2-177