HP Cisco Nexus 5000 Cisco NX-OS System Messages Reference (OL-15994-03, July 2 - Page 792

U6RIB Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message U6RIB-3-PSS Format: Error returned from %s, errno: 0x%08x (%s) in %s() Explanation U6RIB called a PSS API which returned an error. The error reported should be examined for the cause. Parameters: Failed API, Error Code, Error Description, u6RIB Function ... Recommended Action Use 'reload' command to reload the system. Be aware that this problem affects all VDCs on the system. Error Message U6RIB-3-PTADD_ERROR Format: Could not add %s/%d to the %s pt, error code %d Explanation A severe route table error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message U6RIB-3-QADD_ERROR Format: Could not add %s to the %s queue Explanation A severe queue error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message U6RIB-3-QDEL_ERROR Format: Could not delete %s from the %s queue Explanation A severe queue error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' CLI command. Error Message U6RIB-3-RANGE_CHECK_ERR Format: Range check of %s failed from %s (0x%08x) Explanation The value provided is outside of the acceptable range. Parameters: Range, Provider of value, Value Provided ... Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. 2-754 Cisco NX-OS System Messages Reference OL-15994-03