Yamaha A5000 Owner's Manual - Page 11

i o Panel and Connector Arrangement !4 !0 !1 !2 !3 A5000 (The A5000/A4000 also uses the button lamps to let you know that it is receiving MIDI data. Each lamp corresponds to a different MIDI data type, and will continue to blink while the A5000/ A4000 is receiving MIDI data of that type. (page 85)) o [F1] - [F6] Function buttons Use these buttons to switch among the six functions within the currently selected mode. !0 [COMMAND/EXIT] button This button calls the command menu from which you can access a range of commands not included in the modes. Press a second time to revert to the mode display. (page 177, 206) !1 [ASSIGNABLE] button This button can be used to turn off all notes, reset all controllers, switch Knobs 2 through 5 for control change operation, switch the function buttons for tone generator playback, and more. (page 86) !2 [AUDITION] button Press the button to play out the currently selected sample. You use this feature to check the sound of the sample while editing. !3 Floppy-disk drive Accepts a 3.5-inch floppy disk. You can use floppy disks to save and reload your data (programs, samples, sequences, and system settings). Note that there is an access lamp at the lower left of the drive. The lamp lights up while the disk is being accessed. Please do not eject the floppy-disk while this lamp is on. To eject a disk, press the EJECT button at the lower right of the drive. (page 15) !4 POWER switch Press once to switch the power on. Press again to turn the power off. (page 27) • The A5000/A4000 stores all new data into main memory only, and will lose all of this data when you switch off the power. You must therefore be sure to save all important data to disk before turning the A5000/A4000 off. 11 q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q A5000/A4000